![background image](http://html1.mh-extra.com/html/minn-kota/1854035/1854035_manual_1802858008.webp)
8 | minnkotamotors.com
©2022 Johnson Outdoors Marine Electronics, Inc.
d. Under the Left Sideplate, the Extension Damper
obstructs access to the front-left Mounting Hole.
e. Using a small Screwdriver, remove the two 5/16"
E-clips holding the Extension Damper in place. Once
the E-clips are removed, slide the Extension Damper
off the Damper Pins to expose the blocked Mounting
Hole. Set the two E-clips and Extension Damper in
a safe place so they are not misplaced. They will be
reassembled later in the installation.
E-clips
E-clips
Extension
Extension
Damper
Damper
Damper Pins
Damper Pins
Extension
Extension
Damper
Damper
E-clip
E-clip
E-clip
E-clip
Mounting Hole
Mounting Hole
3d
3e
3
NOTICE:
This installation will require four Clipped
Washers (Part #2201725) from the Ulterra Bag
Assembly (Part #2994917).
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high-speed installation tools.
Wetting the screws or applying an anti-seize may help
prevent seizing.
Clipped
Clipped
Washer
Washer
Power Tilt
Power Tilt
Top Plate
Top Plate
Base
Base
Extrusion
Extrusion
Inboard
Inboard
Padlock Slot
Padlock Slot
Hex Head
Hex Head
Cap Screw
Cap Screw
f.
Start with the right side of the Ulterra, where the
Power Tilt is located. There are three Mounting Slots
in the Base Extrusion. These will be used to slide
the Ulterra onto the mounting hardware after it is
installed in the Top Plate (Item #2). Ensure that the
Padlock Slot faces inboard.
g. Take two Hex Head Cap Screws (Item #14), two
Clipped Washers (Part #2201725), and two Nylock
Nuts (Item #16). Insert the Screws into the Top Plate
from the bottom up. When installing the Screws, use
only the two corner mounting holes on the Top Plate.
The center mounting hole will not be used.
h. Place a Clipped Washer on the end of each Screw,
leaving at least 1/4" space between the Top Plate
and Clipped Washer to allow the Base Extrusion
to slide under the Clipped Washers and into place.
Ensure that the flat side of the Clipped Washers
faces toward the Base Extrusion.
CAUTION
Use extra care to avoid pinching and damaging the sensor
wires that run alongside the Base Extrusion when installing and
tightening the mounting hardware.
4g
4
ITEM(S) NEEDED
#2 x 1
#16 x 2
#14 x 2
Base
Base
Extrusion
Extrusion
Top Plate
Top Plate
Clipped Washer
Clipped Washer
4h