MINN KOTA 1854019, Installation Instructions Manual

Page: 10 / 20

a. Position the opening in the Outer Plate over the
Inner Plate. Mount the motor onto the Inner Plate.
b. Slide the Handle Assembly (Item #6) into the rod
holes of the Outer Plate. Slide the Hair Clip Pin
(Item #10) through the Lock Pin to secure the
Handle Assembly.
c. Your motor is now ready to be mounted. Always make
sure the Handle Assembly is fully inserted and
retained by the Hair Clip Pin.
1
#6 x 1 #10 x 1
ITEM(S) NEEDED
1c
For warranty information, please visit minnkotamotors.com.
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001 121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
minnkotamotors.com
©2020 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Part #2374918 Rev H 09/20 ECN 40110
Handle Handle
Assembly Assembly
Hair Clip Hair Clip
Pin Pin
Inner Inner
Plate
Plate
NOTICE:
If the Handle Assembly does not slide
easily into place after completing the installation, it
may be necessary to drill out the Handle Rod Holes
using a letter “F” (.257”) drill bit.
NOTICE:
A padlock can be used in place of the
Hair Clip Pin to prevent motor theft.
1a
Completing the Installation
NOTICE:
To reinstall the lift cylinder for Ultrex motors,
please review the “Installing the Gas Spring Pin” section
of the Ultrex Owner’s Manual (#2297160) online at
minnkotamotors.com .
NOTICE:
To reinstall the lift cylinder for Fortrex motors,
please review the “Installing the Gas Spring Pin” section
of the Fortrex Owner’s Manual (#2287100) online at
minnkotamotors.com .