5 | minnkotamotors.com
©2020 Johnson Outdoors Marine Electronics, Inc.
Completing the Installation
a. Take the Talon Mounting Bracket and align it with the
6” Setback Bracket.
b. Attach the Mounting Bracket using four Stainless Steel
Bolts (Item #4) and four Washers (Item #6). The Bolts
should pass through the Washers and the Mounting
Bracket, then through the 6” Setback Bracket.
1
ITEM(S) NEEDED
#4 x 4
#6 x 8
#8 x 4
Mounting
Mounting
Bracket
Bracket
Washer
Washer
Stainless
Stainless
Steel Bolt
Steel Bolt
1b
1c
d. Next the Talon Assembly should be installed on the
Mounting Bracket. Take the Talon Assembly and
notice that there is an Assembly Track located on
both sides of the Talon.
e. When the Talon is properly oriented as it would
be installed, there is a single Vertical Stop Bolt
located on the Starboard side of the Talon along the
Assembly Track. The Vertical Stop Bolt is used as a
reference point or guideline to stop the Talon and
position the Mounting Straps in the Assembly Track.
Ensure that the Vertical Stop Bolt is secured in the
approximate final position.
f.
Carefully lift the Talon Assembly into the Mounting
Bracket and align the Mounting Straps with the
Assembly Track. Slide the Guard Washers to the
inside wall of the Mounting Bracket, so that they sit
between it and the Talon Assembly. Slide the Talon
Assembly down the Assembly Tracks until it comes in
contact with the Vertical Stop Bolt.
Assembly
Track
Talon
Assembly
Assembly
Track
Assembly
Assembly
Track
Track
Assembly
Assembly
Track
Track
Talon
Talon
Assembly
Assembly
Talon
Talon
Assembly
Assembly
Talon
Talon
Assembly
Assembly
Vertical
Vertical
Stop Bolt
Stop Bolt
Vertical
Vertical
Stop Bolt
Stop Bolt
Mounting
Straps
Mounting
Mounting
Bracket
Bracket
Mounting
Mounting
Bracket
Bracket
Mounting
Mounting
Strap
Strap
Port
Port
Starboard
Starboard
2d
2e
2f
2f
NOTICE:
It is recommended to have a second
person help with this step of the installation.
2
Washer
Washer
Nylock
Nylock
Nut
Nut
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may
help prevent seizing.
c. Secure the Screws with four Washers (Item #6) and
four Nylock Nuts (Item #8). Tighten to 20 ft-lbs
using a 1/2” Box End or Socket Wrench.
