MINN KOTA 1810220, Manual

Page: 6 / 12

3
g. While supporting the Talon Assembly, adjust it and
the Vertical Stop Bolt up or down in the Mounting
Bracket so that the bottom of the Talon Assembly is
not less than 4 inches above the Bottom of the hull
of the boat, or the waterline of the boat. Once in
place, temporarily tighten the Vertical Stop Bolt.
h. Double check the placement of the Talon Assembly
and make sure it meets all of the mounting
considerations. Make any adjustments as necessary.
When the position of the Talon Assembly is
acceptable, secure the four Hex Head Cap Screws
and Nylock Nuts holding the Mounting Straps in
place with a 9/16” Box End or Socket Wrench. Use a
torque wrench to tighten to a recommended torque of
20 to 30 ft-lbs. Tighten the Vertical Stop Bolt.
NOTICE:
For details on Talon mounting adjustments,
please refer to the Owner’s Manual or Installation
Instructions online at
minnkotamotors.com .
CAUTION
Check tension of the 4 vertical adjustment nuts after initial
use and periodically thereafter to ensure they are at the
recommended torque of 20 to 30 ft-lbs.
Vertical Vertical
Stop Bolt Stop Bolt
Setback Setback
Bracket Bracket
Talon Talon
Assembly Assembly
Mounting Mounting
Bracket Bracket
Bottom Edge Bottom Edge
of Talon of Talon
Hull Hull
Hull directly Hull directly
below Talon below Talon
4” Minimum 4” Minimum
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001 121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
minnkotamotors.com
©2020 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Part #2374929 Rev E 06/20 ECN 40714
For warranty information, please visit minnkotamotors.com .