11
Wiring diagram of work trimmer and its supply
4.8 Wiring of the work trimmer
4.8.1 For machines having the Efka stopmotor
- Remove the cover of the work trimmer power supply (1).
- Check the connection of the power supply cable with the
primary winding of the transformer and adapt it, if needed,
as specified in par. 4.2. Mount the cover.
- Pass the connector (2) through the hole for the V-belt in the
table top, fix the cable from the rear side to the machine
head by the attached self-seal clip (be sure to degrease the
seal area first).
- Connect the connector (2) to the plug situated under the
motor of the work cutter.
- Check the sense of rotation of the work cutter shaft whose
end fitted with a notch can be seen through the hole in the
work cutter cover. The shaft must rotate clockwise. If this is
not the case, reverse the polarity of the outputs 3 and 4 in
the feeder (1).
- Connect the connector (4) into the connector (5) on the
connecting cable.
4.8.2 For machine having the clutch motor
- Remove the cover of the work trimmer power supply (1).
- Check the connection of the power supply cable with the
primary winding of the transformer and adapt it, if needed,
as specified in par. 4.2. Mount the cover.
- Pass the connector (2) through the hole for the V-belt in the
table top, fix the cable from the rear side to the machine
head by the attached self-seal clip (be sure to degrease the
seal area first).
- Connect the connector (2) to the plug situated under the
motor of the work cutter.
- Check the sense of rotation of the work cutter shaft whose
end fitted with a notch can be seen through the hole in the
work cutter cover. The shaft must rotate clockwise. If this is
not the case, reverse the polarity of the outputs 2 and 3 in
the feeder (1).
Wiring diagram of work trimmer and its supply
3
2
1
3
2
1
5
4
Summary of Contents for 4182i 100 Series
Page 38: ...14 ...
