Minebea CC-Link CSD-709-73, Instruction Manual, Page: 17 / 48

9
(2) List of commands
Command numbers and the values set in the general data area when a command is issued with a
general command request (request 2) are as follows:
Instructions on writing setting values and operation (selection of write/readout = writing [OFF])
Setting value or command issued
Command no.
(RWwnE)
㻌
General data area
(RWwnC~RWwnD)
㻌
Not used 1
Not used 2
Not used 3
Not used 4
Not used 5
S0 6
S1 7
S2 8
Not used 9
Not used 10
Not used 11
Not used 12
Not used 13
Not used 14
Not used 15
Not used 16
Not used 17
Not used 18
Not used 19
Not used 20
Setting of digital filter (moving average) 7001
Analog filter 7002
Display frequency 7004
Digital filter at 40 times/s of AD sampling frequency 7005
Digital filter at 400 times/s of AD sampling frequency 7006
Digital filter at 4000 times/s of AD sampling frequency 7007
Individual operation key lock 1 7008
Individual operation key lock 2 7009
Analog peak detecting circuit 7012
Setting of CHECK value 7013
Hold target 7018
Comparator operation target 7021
Comparator operating conditions 7022
Comparator hysteresis operating conditions 7024
Comparator hysteresis data width 7025
Comparator hysteresis duration 7026
Selection of operating mode for USB 7040
Selection of output target when F-40 is set to 1 or 2 7041
USB communication settings 7042
Decimal point 7043
Setting of number of digits of unit (combination of load
display and status)
7044
Setting of F key operation 7055
Setting of INPUT1 operation 7060