— END
Exit menu level
— MODE
PC output mode
— OFF
deactivated*
— MAN.OUT
Manual output without stability = device
expects a request via the serial interface.
The response is generated
immediately
.
— MAN.STA
Manual output without stability = device
expects a request via the serial interface.
— INT.OUT
Interval output with 16 characters
without
stability = device sends weight values
automatically without stability in the selected
interval of the update cycles for the display (see
below)
— AUT.OUT
Automatic output
without
stability with 16
characters = device sends weight values
without stability automatically
on every
update
cycle for the display
— AUT.STA
Automatic output with stability
with
16
characters on every value change = device
automatically sends weight values with stability
— INTERV
Specify output interval (if INT.OUT is selected)
— 1 CYC
Every display cycle
— 2 CYC
After 2 display cycles
— 5 CYC
After 5 display cycles
— 10 CYC
After 10 display cycles*
— 20 CYC
After 20 display cycles
— 50 CYC
After 50 display cycles
— 100 CYC
After 100 display cycles
— RESET
Factory settings
— NO
not reset*
— YES
activated
— END
Exit menu level
— BAUD
Baud rate
— 4800
4,800
— 9600
9,600*
— 19200
19,200
— 38400
38,400
5.3.4.6
[PC.OUT] menu selection
The parameters for the PC output can be specified in this menu.
This is an additional interface based on RS-232 with USB-C port.
Factory settings are marked with "*"
PC.OUT
In this case "without stability" means weight values with or without stability.
In this case "with stability" means only weight values with stability!
5.3.4.7
[PC.COM] menu selection
The parameters for the PC communication can be specified in this menu.
Factory settings are marked with "*"
PC.COM
5 Operating
Compact scale Puro® LargeCount
Minebea Intec
EN-51
