These guidelines do
NOT
replace the instructions for use and all users should refer to the appropriate
Operator’s Manual
for detailed instructions.
The Illustrations may not necessarily reflect the setup or data displayed on your device.
BeneHeart R3 Clinical Education Pack SWL 02.07_V1 Mindray UK © 2020. Errors and omissions excepted. Subject to change.
Mindray® is a registered trademark of Shenzhen Mindray Bio-Medical Electronics Co. Ltd.
17
Auto Measurement
In auto measurement mode, the equipment automatically acquires 10 seconds of 12-lead ECG, starts
analysis at the completion of ECG acquisition, then prints the ECG report as per system setup.
To start an auto measurement:
1.
Prepare the patient as described in Patient Preparation.
2.
Enter patient information as described in Patient Demographics.
3.
Adjust waveform speed, waveform size, and the frequency of muscle artefact filter as described in
Setting the Waveform.
4.
If required, check other waveform and report settings by selecting [
Menu
]
→
[
Waveform Setup
]
and [
Report Setup
].
5.
Press the [
ECG
] key to start an auto measurement.
If the [
Preview
] option is disabled, the equipment automatically prints the ECG report after ECG data is
acquired and analysed.
If the [
Preview
] option is enabled, the preview of the ECG report displays. You can then:
•
Press [
F1
] to discard the report and return to the normal screen. From here you may press [
ECG
] if
you wish to try again.
•
Press [
F2
] to send the report to the external device, if connected.
•
Press [
F3
] to print the report.
•
Press
[F4
] to display the next page of the report, if there is any.
The equipment automatically stops recording when the ECG report has been printed. You can also
press [
F4
] to interrupt printing.
Manual Measurement*
In manual measurement mode, the equipment continuously records the ECG waveforms of the
selected lead(s) in real time. You can select the [
Lead
] (number 8) key to change the lead(s) to be
recorded. The labels of selected leads are highlighted with a green background on the screen.
To generate a Manual report:
1.
Follow steps 1 to 4 of Auto Measurement above.
2.
Press the [
Manual
] key to start recording.
3.
Press [
F4
] to stop recording.
In manual measurement mode, press [
F3
] to place a 1mV square wave on the printout.
*Please note that in manual measurement mode no analysis of the waveforms will be made by the
device.
Section 11
Acquiring an ECG
