7
Installation
Mount the speed adjust potentiometer through a 0.38 in. (10 mm) hole with the
hardare provided (see Figure 3, page 8). Install the circular insulating disk between
the panel and the 10K ohm speed adjust potentiometer.
Twist the speed adjust potentiometer wire to avoid picking up unwanted electrical
noise. If speed adjust potentiometer wires are longer than 18 in. (457 mm), use
shielded cable. Keep the speed adjust potentiometer wires separate from power
leads (L1, L2, A1, A2).
Be sure that the potentiometer tabs do not make contact with the
potentiometer enclosure. Grounding the input will cause damage to
the drive.
Warning
m
Speed adjust potentiometer
Line fusing
Protect all Minarik drives with AC line fuses. For XP03-115AC-SL, use fast acting AC line
fuse rated for 8 amps at 250 volts. For all other XP series drives, use fast acting AC line
fuse rated for 3 amps at 250 volts. Fuse only the “hot” side of the AC line (L1).
