50
Troubleshooting
Before troubleshooting
Perform the following steps before starting any procedure in this
section:
1. Disconnect AC line voltage from the drive.
2. Check the drive closely for damaged components.
3. Check that no conductive or other foreign material has become
lodged on the printed circuit board.
4. Verify that every connection is correct and in good condition.
5. Verify that there are no short circuits or grounded connections.
6. Check that the drive’s rated armature outputs are consistent
with the motor ratings.
For additional assistance, contact your local Minarik distributor, or
the factory direct: (800) MINARIK (phone) or (800) 394-6334 (fax).
Warning
Dangerous voltages exist on the drive when it is powered.
When possible, disconnect the drive while troubleshooting.
High voltages can cause serious or fatal injury.
Summary of Contents for XL1100A
Page 69: ...63 NOTES...
Page 70: ...64 NOTES...
