4-13
4
2
Chapter 4 Maintenance
4
Open the right side maintenance cover.
(1)
Rotate the screws under the right side
maintenance cover (for two positions) to the
left and remove them.
(2)
Hold the bottom of the right side
maintenance cover and pull it to the front.
(3)
While pulling the right side maintenance
cover downward, remove it.
• If the right side maintenance cover is hard to
remove, use the supplied screwdriver.
5
Clean the wiper and the bracket, and press
the
key.
(1)
Pull out it by holding projections at both ends
of the wiper.
(2)
Clean with a clean stick including the
cleaning solution (SPC-0369: Cleaning
solution).
•
Wipe off so
that maintenance washing liquid
for maintenance will not remain.
(3)
Insert it in the original position by holding the
projections at both ends of the wiper.
6
Clean the cap rubber , and press the
key.
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance washing liquid
for maintenance.
• Wipe off so that maintenance washing liquid for
maintenance will not remain.
• At this time, the discharge passage is cleaned
automatically.
7
Fill up the cap with cleaning solution for
maintenance, using a dropper.
• Fill the cap with the cleaning solution just before
the solution overflows from the cap.
8
Close the right side maintenance cover
and press the
key.
• Perform the capping operation and wait 1 minute.
• The display provides a countdown display.
• When the resting time has passed, the machine
absorbs the cleaning solution filled in the cap, and
performs cleaning. Then the machine returns to
the display in step 2.
Nozzle Recovery Function
Nozzle Recovery: When nozzles missing can not be
improved at specific points, other good nozzles can be
used as alternatives for printing.
Print the nozzle pattern
Used to print a pattern and to check and/or register
clogged nozzles.
1
Press the
(MENU)
in Local.
2
Press
to select “Maintenance”,
and press the
key.
• Maintenance MENU appears.
3
Press
to select “Nozzle
Recovery”, and press the
key.
4
Press the
key.
5
Press
to select desired head(s)
(H1-2/H3-4), and press the
key.
Right side
maintenance cover
Screw
Projection
• When nozzle missing is not cleared even after this
washing is carried out several times, contact the
distributor in your region or our service office.
