2-12
19
Fix the media to the roll shaft.
(1)
Route the media from the front side of the
tension bar, and fix the media in the center of
the roll shaft with adhesive tape.
(2)
In the same manner, fix the left side and right
side of the media.
• Pull roll media evenly for right and left, check
that there is no slack or waviness on the
media, and paste tape in numerical order.
• When you place the tape, consider the
rolling-up direction.
20
Press
to feed the media about 10 cm,
and then release the lock of the tension
bar.
21
Roll up the media.
(1)
Set the taking-up direction switch to
“Forward”/ “Backward” according to the
taking-up method.
(2)
Press [
] , and rotate the roll shaft 2-3 times
to take up the media.
(3)
Press the [ENTER] key.
22
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• Set the media press to the position of 3mm away
from the media.
• When using a thick media, remove the media
press from the media before printing.
23
Close the front cover.
24
Press the
key to select "ROLL" .
• If the [Setting the Display of Media Detection] of
Machine Setup set in “AUTO”(
P.3-15), the
machine automatically detects the media width.
Roll shaft
Tape
Tension bar
Roll up with the print-
side outside.
Roll up with the print-
side inside.
Recommendation
Tension bar
Lock
•
To take up the media with its print-side facing
inside:
Set the taking-up direction switch to “Backward”.
•
To take up the media with its print-side facing
outside:
Set the taking-up direction switch to “Forward”.
•
To stop taking-up:
Set the taking-up direction switch to neutral (OFF).
Backward
Taking-up with the print side facing to
the inside.
Forward
Taking-up with the print side facing to
the outside.
OFF
Not operated.
Taking-up
manual switch
Taking-up direction switch
Media Press
