2-7
2
2
2
2
11
Push down the clamp lever to hold the media.
12
Set the feeding manual switch to
“Manual”, and feed the media about 10 cm.
• After feeding the media, Make the Feeding
manual switch “AUTO”.
13
Release the lock of the tension bar.
14
Prepare for the take-up device.
(1)
Set the taking-up direction switch to “OFF”
(Center)
(2)
Set the taking-up manual switch to “Auto” (Lower)
15
Raise the tension bar on the front side to
the highest position, and lock the bar.
16
Feed the media to the tension bar.
(1)
Pressing the [
] key, feed the media until the
tension bar at the rolling side is being hidden.
• Check the media end is not caught into the
slot on the platen, and feed the media.
17
Fix the media to the roll shaft.
(1)
Route the media from the front side of the
tension bar, and fix the media in the center of
the roll shaft with adhesive tape.
(2)
In the same manner, fix the left side and right
side of the media.
• Pull roll media evenly for right and left, check
that there is no slack or waviness on the
media, and paste tape in numerical order.
• When you place the tape, consider the
rolling-up direction.
• You can achieve stable media feeding by pulling
the media from in front of the machine so that the
media tension is even on the left and right when
you push down the clamp lever.
Clamp lever
Taking-up manual
switch
Forward
Taking-up with the print side
facing to the outside.
OFF
Not operated.
Manual
Auto
Taking-up direction switch
Backward
Taking-up with the print side
facing to the inside.
Tension bar
Lock
Roll shaft
Tape
Tension bar
Roll up with the print-
side outside.
Roll up with the print-
side inside.
Recommendation
