MIMAKI GP-604D, Operation Manual

Page: 59 / 134

- 3.5 -
9. Clean the used wiper with water, and dry it.
• If dirts or curl is serious, replace the wiper with a
new one. At the time of replacement, make sure
to terminate the plotter operation and follow the
wiper replacement procedure. page 5.5
10. Hold the projections at both ends of the
cleaned wiper to insert to the place.
11. Wipe off ink or dirt adhered to the rubber of the
cap and the ceiling of the wiper cover using
cotton buds.
• Be careful not to leave lint of the cotton bud.
Lint may cause plotting failure.
• Wipe the head sides with a cotton bud as ink
may be adhering there also.
12. Press the [ENTER] key.
After performing the initial operation, reverts to the LOCAL
mode.
INITIALIZING
PLEASE WAIT
< LOCAL >
WIDTH : 610 mm
Wiper Cover