MIMAKI GP-604D, Operation Manual

Page: 11 / 134

- vii -
Precautions in use
CAUTION
Use the ink specified
• Use the GP-604D genuine ink.
The plotter does not operate
with other ink than the GP-604
genuine ink.
• Do not use the GP-604D
genuine ink for other plotters as
doing so may cause damage to
other plotters.
Periodic exchange parts
•
There are some parts which
must be replaced by service
men. You have to make a
contract with distributors or
dealers for after-sale service.
Relocation of the device
• The device may be relocated
within the same floor without
steps. For safety reasons, it
must be carried by at least four
persons.
Protection against dust
• It is strongly recommended to use
the device in a room that is not
dusty. Set the Refresh level 2 or
3 when in bad environment.
( page 4.8)
• Keep the front cover to be closed
also when the device is not
engaged in printing. If not, dust
can accumulate on the head
nozzle.
• When leaving the workshop after
the working hours, be sure to take
off any garment from the table.
If any media is left on the table,
dust can put on it.
• Keep the garment (T-shirts)
protected from dust.
• Frequently wipe the capping
station clean to eliminate dust
and lint.
Dust in the head will also cause
drops of ink to fall abruptly down
on the garment during printing. If
this phenomenon takes place, be
sure to clean up the head.
( page 2.9, 4.9)
Front cover
• Never open the front cover
during printing. Opening the
cover will abort printing.
Garment
• If garment that is likely to tightly
curl, flatten first the paper before
using it for printing. Heavily-
curled garment affect the plotted
result.