MIMAKI CG-100SRII, Operation Manual

Page: 117 / 150

3-69
Miscellaneous Settings
3
Use
ful Func
tion
Setting List
Function
name
Outline Setting values
Mark
Detect
When you cut the data with
registration marks, you must set
without fail.
See P.3-18.
Command
Switching Switch the unit of moving amount
specified by a command.
AUTO
This is to automatically switch the command
according to the command specifications of
the receiving data.
MGL-IIc
This is selected when the plotter receives the
data of MGL-IIc command.
MGL-Ic1
This is selected when the plotter receives the
data of MGL-Ic1 command.
Interface
Set the configuration with a com-
puter.
See P.3-56.
Device
No. Set each device number for USB
connection
See P.3-58.
Cutting
Mode
This is to set the cutting quality.
Standard This is a regular cutting mode.
High speed
This is used to perform cutting in a short time
(it is not appropriate for the heavy sheet).
High quality
This is a cutting mode used to give priority to
cutting quality.
Origin
Switching
At the time of MGL-IIc command,
this function sets the position of
command origin.
(At the time of MGL-Ic1 command,
the command origin is positioned in
the lower right.)
Center
This is to set the command origin in the
center of effective cutting area.
Lower right
This is to set the command origin in the lower
right of effective cutting area.
Expamds
Reduce the dead space to extend
the cutting (plotting) area.
See P.3-39.
Rotation Switch the cutting direction. See P.3-41.
Buzzer
With this you can control the key-
pressing sound and the alert sound
caused at the time of error
occurrence.
ON This is for making the buzzer sound.
OFF
This is not to make the buzzer sound
(also make no confirmation response sound
of registration mark sensor).
Division
Cut
Set the division cut. See P.3-43.
Half Cut Set the cutting with a dotted line. See P.3-59.
Pouncing
Set the plotting with the punching
(dot) function.
See P.3-61.
Priority
When this plotter and the host
computer make different settings on
a same item, this function is used to
set about which of the two must be
given priority to (This is only for
MGL-IIc).
Host
This is to give priority to the setting of host
computer.
Panel
This is to give priority to the setting of this
plotter.
Size
Response
Value
This is used to set the largest
response value of effective area
read command from the host
computer (This is only for MGL-Ic1).
1 to 51m
Sheet
Sensor This is to detect the sheet existence
and the sheet length.
ON This is to detect them.
OFF This is not to detect them.