Functions in the Jog Mode
3-5
3
Use
ful Func
tion
Digitization operation
The coordinates of the plotted figure relative to the origin are displayed on the host computer.
Upon receiving the digitization command (DP;) from the host computer, the plotter is ready for digitization
operation.
To conduct digitization, install a sheet with patterns to select points on it.
1
Set the plotter in the remote mode and
make it receive the digitization
command from the host computer.
• The display will change as shown at right.
2
Move the pen with a jog key
or
until the pen tip
reaches a given point of the pattern.
• The coordinates relative to the origin will be displayed.
• If you set the step to a smaller value using the jog step function, you may select a desired
point with increased accuracy. (
P.3-70
)
3
Press the
key.
• The plotter records the point of the pen head.
• The plotter receives the coordinate output
command (OD;) from the host computer.
• The digitization operation is available only with an application software that incorporates a
digitization function. Refer to the instruction manual for the application software for how to use
the digitization function.
P E N
*
R E M O T E
*
* *
D I G I T I Z E
* *
1 0 0 . 0
2 5 0 . 5
P E N
*
R E M O T E
*
ENTER/HOLD
Summary of Contents for CG-100SRII
