MIMAKI CG-100SRII, Operation Manual, Page: 134 / 150

5-2
Specifications of the main unit
Item CG-100SRII CG-130SRII
Acceptable sheet width
mm inch mm inch
90 ～ 1250 24 ～ 48 90 ～ 1550 24 ～ 60
Acceptable roll sheet
外形 :150mm 以下、 Sheet weight : 8 kg or less
Effective cutting area
*1
*1: The maximum feed length is limited by the software.
The maximum feed length is limited also by the sheet setting condition or by the effect of obstacles
encountered on the sheet path. As a rule of thumb, limit the maximum feed length for one of the data to 2
m.
1070 mm X 51 m 1370 X 51m
Maximum speed Apporox85 cm/s (in the 45-degree direction with the pen up.)
Speed setting
(cutting/plotting)
1 ～ 10m/s (in 1 cm/s steps)
10
～
60cm/s (in 5 cm/s steps)
Mechanical resolution 5 μ m
Program steps
25, 10 μ
ｍ
(MGL-IIc)
100, 50, 25 μ m( MGL-Ic1)
Repeatability
*2
*2: To achieve the guaranteed range of accuracy, the next page's requirements must be satisfied.
±0.2 mm (excluding expansion/contraction due to film temperatures)
Guaranteed range of
accuracy (repeatability)
1070 mm X 2 m 1370 X 2m
(depending on the specified film and cutting conditions)
Maximum pressure 400 g
Pressure
setting
Cutter
10
～
20g(2 g step)
20
～
100g(5 g step)
100 ～ 400g(10 g step)
Pen
10 ～ 20g(2 g step)
20
～
100g(5 g step)
100
～
150g(10 g step)
Acceptable films
PVC sheets (0.25 mm thick or less,
included laminated sheet
),
fluorescent sheets
*3
, reflective sheets
*4
*3: The blade (SPB-0007) dedicated for fluorescent sheets or the blade (SPB-0006) dedicated for reflective
sheets must be used.
Acceptable sheet for
pouncing
Paper (thickness: 0.06 to 0.13 mm)
*4
*4: The dedicated pouncing tool must be used.
Applicable tools
Eccentric cutters,water-based ball-point pens, oil-based ball-point
pens, commercially available ball-point pens
*5
*5: Use the tools supplied as standard accessories.
If any other ball-point pen available on the market is to be used, select the one whose diameter is 8 to 9
mm and which is free from bumps or taper in the area to be clamped. The image quality is not guaranteed
because the pen tip position differs depending on the pen in use.
Commands
*6
*6: With the USB connection, the ESC type commands among the MGL-llc commands cannot be used.
MGL-IIc
、
MGL-Ic1
Interface USB, RS-232C
Receiver buffer 30 MB standard (20MB when the sorting function is effective.)
Operating environment 5 to 35°C, 35 to 75 % (Rh) Non-condensing
Power capacity AC100 to AC240 V 120 VA or less
Outside
dimensions
(W) 1435 mm 1735 mm
(D) 580 mm
(H) 1125 mm
Weight 38 kg 44 kg
Noise
*7
*7: The values are based on MIMAKI's measurement conditions.
During standby (plotting) 50 dB (Absorption fan at low speed)
During cutting (plotting) 70 dB (Continuous sounds)