MIMAKI CG-100SRII, Operation Manual

Page: 120 / 150

3-72
Priority
Setting of priority is available with MGL-II c commands.Specifically, setting of priority is applied to the follow-
ing commands.
Size Reply Value
The setting value does not affect the actual available cutting area.
If the detected sheet size is smaller than the value of [DISTANCE], the detected size is sent to the computer
as the reply value.
Sheet Sensor
The sheet sensor may not detect any transparent sheet or sheet whose back side is black. In such a case,
the display shows the following error message.
Even in this case, cutting is enabled by setting the [SHEET SENSOR] function contained in the SET UP of
FUNCTION to OFF.
• When the [SHEET SENSOR] function is set to OFF, set the cutting area; otherwise, the plotter may
perform cutting for data outside the sheet or continue cutting even after there is no sheet left.
Jog Step
Accurate positioning can be achieved in any of the following cases:
• Two-point axis alignment (
P.3-3
)
• Precise location of the origin
• Digitization (
P.3-5 )
FEED OPTION
FEED OFFSET:
During auto feeding, the paper tube may move unsteadily when the roll sheet comes close to its end.
Feed the roll sheet with an extra feed by a certain length to prevent the roll sheet from dropping from the roll
bars as a result of unsteady moving of the paper tube.
FEED SPEED:
In the case of using especially heavy roll sheet, the machine burden is reduced by slowing down the feed
speed.
Pen selection command SP;
Pen lowering speed setting command VS;
Pen lifting speed setting command ZA;
Acceleration setting command AS;
Pen pressure setting command
FS; 、 ZF;
Cutter blade compensation setting command ZO;