Milnor 7272TG1L, Installation And Service

Page: 30 / 206

4biUb 9^cdQ\\QdY_^
@5<<5B9> =9<>?B 3?B@?B1D9?>
"#
<PRWX]Tc^<PRWX]T1aPRZTcb
—Machine to machine brackets hold paired dryers in place
after each machine is anchored and leveled. Install these brackets as follows:
• Install the rear brackets (Figure 5).
• Assemble front machine-to-machine leg bracket. Mark and drill mounting holes and install
the leg bracket (Figure 5).
• Install bolts between the front lift plates of adjacent machine pairs. Do not tighten bolts at this
time.
• Slide the lift plate spacers in between the front lift plates (Figure 5). Tighten bolts when done.
Figure 5: Machine-to-Machine Brackets and Spacers
Rear machine-to-machine
bracket (two locations)
Front machine-to-machine leg bracket Adjacent front lift plates
showing installed spacers
and bolts
Lift plate spacer
"$
2WTRZ2h[X]STa8]cTaX^a
—Check the interior of the perforated cylinder for smoothness
before placing the machine in service. Milnor cannot accept claims for damage to the cylinder's
smooth finish after the machine has been placed in service.
— End of BIPD6I02 —
24