Milnor 7272TG1L, Installation And Service

Page: 29 / 206

4biUb 9^cdQ\\QdY_^
@5<<5B9> =9<>?B 3?B@?B1D9?>
!!
5^d]SPcX^]
—The machine must be anchored in accordance with the installation instructions.
The floor and/or all other support components must have sufficient strength (and rigidity with
due consideration for the natural or resonant frequency thereof) to withstand the fully loaded
weight of the machine including the wet goods and any repeated sinusoidal (rotating) forces
generated during its operation. Determining the suitability of floors, foundations, and other
supporting structures normally requires analysis by a qualified structural engineer.
"
0bbT\Q[h
"
8]bcP[[X]VcWT;TVb^]cWT7^dbT
—It is usually easiest to install the legs on the house
then use a fork lift to set the machine in place.
1. Read all related tags prior to assembly.
2. Verify that the doors are closed and secured.
3. Unfasten house from the shipping skid. Once skids are removed, take care in placing forks
under the machine. Do not allow forks to come in contact with valves, piping, motors,
etc., located under the machine.
4. Install the provided foam seal along the path indicated by decals on the machine. This seal is
only installed on the left side machine of a left and right pair (Figure 4).
5. Raise the house using the three designated lifting plates located on the top of the machine.
6. Install the legs and filler plates on the house.
7. Remove the spreader bar (Figure 3).
8. Carefully move the machine into place.
9. Repeat the assembly process as required for the adjacent machine (if paired).
"!
0]RW^aX]V
F0A=8=6 ! ) 2adbW P]S <PRWX]T 3P\PVT 7PiPaSb—This machine has a rearward
center of mass and will fall rearward (toward the discharge end) if not properly anchored to the
foundation.
• Install anchor bolts as soon as machine is in position and before making service
connections. Install anchor bolts in accordance with the dimensional drawing.
• Keep bystanders clear of machine during installation.
Machines must be securely anchored to an adequate foundation. Anchor bolt locations and
foundation specifications are provided on the dimensional drawing (see Table of Contents).
Never install anchor bolts securely in the foundation using only the information on the
dimensional drawing. Anchor bolts must not be installed until the machine is on site so that the
machine itself may be used to determine precise anchor bolt locations. Consult Milnor if any
obstruction prevents the installation of any anchor bolts. Anchor bolts cannot be
indiscriminately omitted.
""
;TeT[X]V?a^RTSdaTb
1. After the anchor bolts are installed, level the machine both left to right and front to back by
inserting shims under each foot pad as needed.
2. Use a carpenter's level to verify that the machine is level.
3. Tighten all foundation bolts until they contact the top of the base plates.
4. Tighten all the bolts evenly, one-quarter of a turn each time on every bolt until all bolts
are uniformly tight. After tightening, check each fastener separately at least twice.
23