Milltronics OCM II PL-269, Instruction Manual

Page: 93 / 107

CALIBRATION FLOW CHART
F0 [2.71828] Access Program Mode
P0 [ ] Dimension Units
(0 = cm., 1 = in.)
P1 [ ] Temperature Units
(0 = °C, 1 = °F)
P2 [ ] Primary Measuring Device,
(Selected from Table 3)
If P2 = 0 If P2
≠
0
Enter required parameters
selected from Table 4
U0 [ ] Max. Flowrate U0 [ ]
U1 [ ] Flowrate Units U1 [ ]
(0=/sec,1=/min,2=/hour, U2 [ ]
3=daily) U3 [ ]
U2 [ ] Max. Head U4 [ ]
U3 [ ] Exponent U5 [ ]
U6 [ ]
U7 [ ]
P3 [ ] Display Mode
(0=Head,1=Flowrate,2=Total Flow)
P4 [ ] Distance to Zero Level
(F12, auto zero may be used)
SIMPLE CALIBRATION COMPLETE, enter F5, F7 and F2; OR CONTINUE ADVANCED CALIBRATION
P5 [ ] Low Head Cutoff%
(Flowrate=zero if below this % point)
P6 [ ] Failsafe Mode
(0=Hold,1=High,2=Low)
P7 [ ] Failsafe Timer
(Seconds from echo loss to Failsafe)
P8 [ ] Relay Function
(0=none,1=High head alarm,2=High flow alarm,3=Low head alarm,
4=Low flow alarm,5=Time activated sampler-contact(min),
6=Flow activated sampler-contact (engineering units)
P9 [ ] Relay Setpoint
(Desired relay activation value)
P10 [ ] Relay Deadband
(% difference activate vs deactivate)
P11 [ ] Current Output Mode
(0=Flowrate,1=Head,2= Velocity, 3=Fixed Maximum,4=Fixed Minimum)
P12 [ ] Current Output Damping
(From .1 sec. to 600 sec.)
P13 [ ] Current Output Range
(0=4-20mA, 1=0-20mA)
P14 [ ] Log Site #
(Identifies data log information origin)
P15 [ ] Totalizer Multiplier
(For totalizer vs display units)
P16 [ ] Auxiliary Printer Enable
(0=None,1=English,2=French, 3=German,4=Italian)
P17 [ ] Print Interval Units
(0=min,1=hours,2=daily)
P18 [ ] Print Start
(Refer to Table 3)
F5 [ ] Current Time
(## hours, ## minutes, 00 seconds)
F7 [ ] Current Date
(## day, ## month, ## year)
F2 Calibration Complete (Enter run mode)
PL-269 9 – 15