Milltronics OCM II PL-269, Instruction Manual

Page: 79 / 107

APPENDIX A
ERROR CODES
1. Numeric underflow: probably a bad U parameter or incorrect flow program P2.
2. Numeric overflow: probably a bad U parameter or incorrect flow program P2. P9 to small, relay is
pulsing once every 2 seconds until the totalizer is overflowed at high flowrates.
3. Attempt to divide by zero: check parameter entries.
4. Bad argument (e.g. attempted square root of a negative number): check parameter entries.
5. Attempt to access non-existent parameter.
6. Access to parameters denied: security code has not been entered.
7. Primary element exceeds BS-3680 dimensions or head exceeds the max. range of BS-3680
specifications; bad U parameter.
8. Conversion overflow (long floating point to short floating point):
Inappropriate choice of flow or time units, (U0 or U1) causing logging total overflow.
Bad U parameter causing excessive flowrate to be calculated.
9. Requested date is not in data log:
date has not been entered in correct format.
calendar was not set correctly on start up.
10. Attempt to select non-existent primary element of P2
PL-269 9 – 1