Miller FieldPro Smart Feeder CE, Owner'S Manual

Page: 37 / 56

OM-264234 Page 31
Display Code
Description
Fault
H44 Low Motor Bus Voltage Indicates input primary line voltage is too low. In-
crease primary line voltage to at least 90% of speci-
fied nominal voltage. If this code to appear on display,
contact nearest Factory Authorized Service Agent.
H45 Button Is Stuck On Feeder Release button. If this code continues to appear on
the display, contact nearest Factory Authorized Ser-
vice Agent.
H46 Trigger Stuck Fault Indicates trigger stuck fault. Fault will clear when trig-
ger is released.
H48 Trigger Fault Indicates trigger was held too long in trigger jog (the
lesser of 60 seconds or 30 ft (9.1 m) of wire.
H51 Motor Supply Over Temperature Indicates motor supply have overheated. Unit has
shut down to allow fans to lower temperature. Opera-
tion will continue after unit is within normal tempera-
ture range.
H52 Motor Over Temperature Indicates motor has overheated. Unit has shut down
to allow fans to lower temperature. Operation will con-
tinue after unit is within normal temperature range.
H53 Motor Supply Temperature Sensor Fault Indicates motor supply sensor malfunction. If this
code appears, contact nearest Factory Authorized
Service Agent.
H54 Motor Temperature Sensor Fault Indicates motor sensor malfunction. If this code ap-
pears, contact nearest Factory Authorized Service
Agent.
H60 Bad Memory Card Indicates unable to read memory. Faulty memory card
or wrong format.
H61 File Read Error Indicates faulty file on memory card.
H62 File Write Error Indicates full or faulty memory card.
H63 File Write Error Indicates an invalid file on memory card. The system
was able to read the file; however, the contents of the
file were invalid. Remove card or press any button to
clear error.
H64 Card Locked Indicates a save was attempted to a locked card. This
refers to the physical switch on the memory card. Un-
lock the memory and try again. Try a different memory
card. Remove card and press any button. Remove
card or press any button to clear error. If this code
continues to appear on the display.
H65 Read − Only File Indicates a save was attempted to a file that has been
marked read − only. Check with the appropriate person
to see if the attributes are read only for a reason (the
attributes can be altered using a PC). Use a different
card. Remove card or press any button to clear error.
H66 No Memory Card Detected Indicates no memory card detected when a memory
card operation was attempted. Insert a card or press
any button to clear error. Try a different memory card.
If this code continues to appear on display, contact
nearest Factory Authorized Service Agent.
H67 Unsupported Memory Card Format (FAT12) Indicates card format issue. Verify correct memory
card is being used. If this code continues to appear on
display, contact nearest Factory Authorized Service
Agent.
H70 Missing/Incomplete Weld Library Indicates missing/incomplete weld library in power
source. Weld library must be loaded from memory
card.
H80 Output Current When Output Is Disabled Indicates current malfunctions in secondary circuit. If
this code appears, contact nearest Factory Authorized
Service Agent.
H81 Output Current On Channel 1 Too Low Indicates current malfunctions in secondary circuit. If
this code appears, contact nearest Factory Authorized
Service Agent.
H82 Output Current On Channel 2 Too Low Indicates current malfunctions in secondary circuit. If
this code appears, contact nearest Factory Authorized
Service Agent.