Miller FieldPro Smart Feeder CE, Owner'S Manual

Page: 21 / 56

OM-264234 Page 15
Associating the FieldPro Smart
Feeder to the PipeWorx 350
FieldPro power source:
1 Connect the feeder to the welding
power source as shown in Section
5-8.
2 Turn on the welding power source
and wire feeder. The welding
power source will display the last
amperage set point and the wire
feeder will display three dashes
until connected. Allow 60 seconds
for system to connect.
3 Once feeder is communicating
with power source, the power
source will display “Acc” and the
wire feeder will display preset
voltage and wire feed speed.
4 The preset welding voltage and
wire feed speed can now be
adjusted with the voltage control
on the wire feeder while welding.
While welding, the wire feeder
displays weld voltage at the
feeder. The power source displays
amperage from feeder while
welding and will maintain
amperage display for 10 seconds
after welding.
Set welding program for your specific
application
5-5. Equipment Setup
264 175-B / 264 178-C / 264 180-B
IN USE
FEEDER FRONT PANEL
FEEDER FRONT PANEL
FEEDER SETUP PANEL
FEEDER FRONT PANEL
SD CARD SLOT
POWER SOURCE
POWER SOURCE