EasyCUT
MM148-001
– Operator Manual
15
3.1. Adjusting the air flow direction
It is possible to adjust the air flow direction, following the instructions below:
1.
Turn off EasyCUT pressing the button shown in the picture, on “0”:
2. Slightly loosen the black knob (indicated by the yellow circle).
3. With both hands turn the ionizing bar in the desired position, paying attention not to insert fingers in
the slots where needles are located.
Never insert objects inside the slots where the ionized air comes out from otherwise
electric shocks could occur.
Use caution to avoid the risk of hand and or finger crushing during the ionizing bar
movement.
4. At the end, keeping the ionizing bar in a hand, move the fan in the desired position and tighten the
black knob.
5. Turn on EasyCUT and cut the blocks.
