74
Table 4-5-15 Description of the buttons
Parameters
Function Introduction
Zoom Status
Configure the OSD parameter, and you can set the Zoom status OSD with Close/
Always open/ 2s/ 5s/ 10s.
Pan&Tilt Status
Configure the OSD parameters, and you can set the Pan&Tilt status OSD with
Close/ Always open/ 2s/ 5s/ 10s.
Preset Status
Configure the OSD parameters, and you can set the Preset status OSD with Close/
Always open/ 2s/ 5s/ 10s.
Preset Freezing
If you enabled Preset Freezing, the live view of preset position will be showed
directly instead of showing both the moving path to the position and the live
view. It can also reduce the use of bandwidth in a digital network system
Preset Speed
It determines the speed of calling presets. Level 1~10 are available.
Manual Speed
(Speed Dome)
It determines the PTZ speed of Manually control.
Low
/
Medium
/
High
are
available.
Scan Speed
(Speed Dome)
It determines the speed of Auto Scan. Level 1~10 are available.
Patrol Recovering
(Mini PTZ Bullet)
Click to enable Patrol Recovering.
Patrol Recovery Time
(Mini PTZ Bullet)
Set time for Patrol Recovering, which is between 5 and 720 seconds.
Focus Mode
Three focus modes are available: Auto/ Semi-Auto/ Manual.
Minimum focus
Distance
(Speed Dome)
Set the minimum focus distance to adjust the step length of each focus. 1 meter,
1.5 meters, 3 meters, 6 meters, 10 meters, 20 meters are available.
Set Resume Time
If the camera stop working for a longer time than predefined,
the position of it will be recorded. And it will resume the position after it restart
from a power-off. You can set the resume time to 30 seconds, 60 seconds, 300
seconds or 600 seconds to record its position.
