AguaBot 5.0 Troubleshooting
Aguabot 5.0
M I L A G R O W
12
Error Codes Chart
Error code will show on display panel if there is a problem with the AguaBot
Note: if the error condition is not resolved, by suggested solution, do the following:
Restart the robot by switching the power switch off and on.
If restarting doesn't solve the problem then, remove battery for more than 10
minutes to reset the system.
If problem persists, then contact Milagrow service for repair at
www.milagrowhumantech.com
1.
2.
3.
Clean the cliff sensor with cotton swabs
Remove hair and debris from the wheels,
push them in and out and check whether
the wheels can turn freely
Remove and clean the side brushes
Place the Robot on flat floor
Move the Robot to docking station
for charging
Turn the power switch to "ON" or insert
the battery correctly
Check Bumper can move freely &
it's free from any debris
Clean the bumper sensor window
Replace with new battery
1
2
3
4
12
13
14
15
23
Cliff Sensor Fail
Left or Right Wheel Error
Left or Right Side Brushes
Error
Unit is lifted up
Low power
The Power of the Robot
isn't Turned On or The
Battery isn't Installed
Correctly
Front Bumper Error
Bumper Sensor Error
NTC error
Error Code Cause
Solution
