AguaBot 5.0 Troubleshooting
Aguabot 5.0
M I L A G R O W
14
Battery Installation/Replacement on AguaBot Main Unit
Remove the two screws from the battery cover, with a screw driver
Open the battery cover.
Take out the battery using the 2 strip holders on its sides
Disconnect the wire connector that connects the battery and unit.
Put a new battery into battery slot with 2 strip holders face up
Reconnect the wire between the battery and unit correctly.
Make sure the wire connector is stored on the cavity.
Put the battery cover back and make sure side brush is not stuck in.
Lock the back battery cover with screws.
A.
B.
C.
D.
E.
F.
G.
H.
I.
Note: Only use Milagrow Authorized Batteries
The AguaBot is not for commercial use. It is for personal use at homes and small
offices, etc. It is for indoor use and use on dry or moist floors. It will clean the debris, dirt,
dust, and pet hairs off the floor, and work well on hardwood, tile, linoleum, and low-pile
(up to 0.5 inches) carpets.
Usage Limitation
MILAGROW
Aguabot 5.0
Battery Cover
