Frequently asked questions . . .
45
The program is cancelled and a fault indicator light lights up on
the control panel
Problem
Possible cause and solution
The fault indicator
light
lights up,
and
appear
alternately on the time
display, and the buzzer
sounds.
The water inlet is blocked or restricted.
Check whether the tap is turned on properly.
Check whether the inlet hose is kinked.
Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
Clean the filter.
The fault indicator
light
lights up,
and
appear alternately
on the time display, and
the buzzer sounds.
The drain is blocked or restricted.
The drain hose has been fixed too high.
Clean the filter and the pump.
The maximum drain height is 1 m.
The fault indicator
light
lights up,
and
appear
alternately on the time
display, and the buzzer
sounds.
The water protection system has reacted.
Close the tap.
Contact the Service department.
and
appear
alternately on the time
display and the buzzer
sounds.
There is a fault.
Disconnect the washing machine from the
electricity supply, either by switching it off at the
wall socket and withdrawing the plug, or by
disconnecting it at the circuit breaker.
Wait
at least 2 minutes
before reconnecting the
washing machine to the electricity supply.
Then switch the washing machine on again.
Restart the program.
If the fault message appears again, contact the
Service department.
Summary of Contents for WWB 020
Page 54: ...54 ...
