Miele WWB 020, Operating Instructions Manual

Page: 29 / 80

Spinning
29
Final spin speed in the wash
program
When a program is selected, the sensor
button for the optimum spin speed for
that program will be brightly lit up on
the control panel
A faster spin speed can be selected for
certain wash programs.
The highest selectable spin speed is
indicated in the table.
Omitting the final spin (Rinse hold)

Touch the

sensor button (Rinse
hold).
The laundry is not spun after the final
rinse and remains in the rinse water.
This helps prevent creasing if the
laundry is not going to be removed from
the drum immediately after the end of
the program.
After the end of a program
The sensor button for the optimum
spin speed lights up on the control
panel. You can change the spin speed.
The
Start/Stop sensor button will flash
slowly.
 To start the final spin:
Touch the flashing
Start/Stop sensor
button once .
The final spin is carried out.

To end the program:
Touch the flashing
Start/Stop sensor
button twice .
The water will be pumped away.
Deselecting the rinse-spin and final
spin

Touch the

sensor button.
After the final rinse cycle, the water will
be pumped away and the Anti-crease
phase will switch on.
An Extra Rinse cycle is carried out with
this setting for certain wash programs.
Rinse-spin
There is a spin cycle after the main
wash and between the rinse cycles. A
reduction in the final spin speed will
also reduce the interim spin speed as
appropriate. If a spin speed of less than
700 rpm is selected for the
Normal program, an Extra Rinse phase
is carried out.