Installation and connection
74
Installation surface
A concrete floor is the most suitable
installation surface for a washing
machine, being far less prone to
vibration during the spin cycle than
wooden floorboards or a carpeted
surface.
Please note:
The machine must be level and
securely positioned.
To avoid vibrations during spinning,
the machine should not be installed
on soft floor coverings.
If installing on a wooden joist floor:
We recommend a plywood base at
least 59 x 52 x 3 cm). The base
should span several joists and be
bolted to the joist and not only the
floorboards. Check for the presence
of pipes and cables first.
Tip:
If possible, install the machine in a
corner, as this is usually the most stable
part of the floor.
There is the danger of the
washing machine moving about
during spinning and falling off a
plinth.
For this reason, if the machine is
installed on a raised plinth (concrete
or brick), it has to be secured against
slippage using an MTS floor/plinth
mounting kit (available from Miele).
Transporting the washing
machine to its installation site
Make sure the fixings at the back
of the lid are secure.
Otherwise there is a danger of the lid
being pulled off when carrying the
machine.
Before carrying the machine check
that the lid is secure where it
protrudes at the back of the
machine.
Carry the washing machine by the
front feet and the protruding lid at the
back.
Removing the transit bars
To remove the left and right covers
1. Pull on the attached stopper,
2. then use a screwdriver to release the
catches at the top and bottom.
Summary of Contents for WCE 660
Page 100: ...M Nr 11 011 430 00 en SG WCE 660 ...
