Features
Display
The display shows:
– the programme duration (time
remaining);
– the delay start time;
– check messages;
– programmable functions.
Estimated time remaining
The electronics calculate the drying
time a few seconds after the
programme has started. During this
calculation period, bars will flash in the
display (
===
...
-==
...
==
...). The estimated
drying time will then appear in the
display. Please be aware that it is only
an estimate!
The following factors all affect the
estimated time remaining: Residual
moisture content after spinning; type of
fabric; size of load; room temperature;
fluctuations in power supply.
The electronics continually assess
conditions in the machine and adjust
the estimated time remaining for a more
accurate reading. Because of this the
time displayed can alter during the
course of a programme.
If the time remaining stops counting
down shortly before the end of the
programme and bars start flashing in
the display, this is not a fault.
The drying programme is a little longer
than was originally indicated.
Buttons and check lights
The relevant indicator light comes on
each time a button is pressed.
PC / Optical interface
The indicator or check light marked PC
is explained in "After Sales Service".
Drum lighting
If the dryer is switched on, the drum
lighting will come on when the door is
opened. It will go out after a short while
if the door is left open to save energy.
Electronic system lock
This can be used to lock the electronics
to prevent the dryer being used without
your knowledge.
Programmable functions
The programmable functions allow you
to change standard settings.
Operating the tumble dryer
10
Summary of Contents for T 4452 C
Page 46: ...46 ...
Page 47: ...Programmable functions for changing standard settings 47 ...
Page 54: ...54 ...
Page 55: ...55 ...