Note
If the nozzle was run over smooth flooring (e.g., parquet or tile) while in the
“
Automatic
”
setting, the motor will run at its highest speed due to the air coming
in at the sides of the nozzle.
Cause
Pressure sensor on the electronic board is defective.
Remedy
A
Pull off the hose between the control panel and the dust compartment lid (040
Fig. 5, Pos. B).
A
Switch the motor on in the "Automatic" setting.
A
Generate a low-pressure condition at the disconnected end of the hose (e.g.,
quickly suck an object in).
A
If the motor speed does not drop, then the pressure sensor is defective.
A
Replace the electronic.
Descriptive Technical Documentation
DTD no. 41-8000
040-7
07.06.2013, US_am
This information should not be duplicated or passed on without Miele approval. All rights reserved.
