Operation
45
Switching off
At the end of a program:
Open the door.
The dishwasher can be switched off
at any time using the
button.
Switching the dishwasher off during a
program stops the program.
Turning the dishwasher off during the
run-up to a delay start time (FlexiTimer)
will also stop the process.
If the dishwasher is not going to be
used for a longer period of time, e.g.,
while on vacation, the water supply
should be turned off.
Unloading the dishwasher
Dishes tend to break and chip more
easily when they are hot. Allow the
dishes to cool until they are comfortable
enough to handle before unloading
them.
The dishes will cool much faster if you
open the door when the program has
ended.
First unload the lower basket, then the
upper basket, and finally the cutlery
tray.
This will prevent water drops from the
upper basket and cutlery tray from fall-
ing onto the dishes in the lower basket.
Interrupting a program
A program will be interrupted as soon
as the door is opened.
If the door is closed again, the program
will continue from the point it was at be-
fore the door was opened.
Water in the dishwasher may be
hot. Danger of scalding!
Only open the door if absolutely nec-
essary and exercise extreme caution
when doing so. Before closing the
door again, leave it ajar for approx.
20 seconds. This will enable the tem-
perature in the wash chamber to set-
tle. Raise the door upwards until the
catch engages.
Changing a program
If the detergent dispenser flap has al-
ready opened, do not change the
program.
If a program has already started and the
customer wishes to change it, proceed
as follows:
Open the door.
Turn the dishwasher off with the
button.
Turn the dishwasher on again with the
button.
Select the program you want, and
then start it by shutting the door.
The in-operation indicator comes on to
show that a program has been started.
