Problem solving guide
48
Problem
Cause and remedy
After the hob has been
switched on
appears
in the timer display for a
few seconds. The
cooking zones do not
heat up.
The hob is in demonstration mode.
Touch the
and
sensors at the same time until
flashes alternately with
in the timer display.
A cooking zone
switches off
automatically.
It has been operated for too long.
You can use the cooking zone again by switching
it back on (see “Safety switch-off”).
The food in the pan
does not heat up when
the Auto heat-up
function is switched on.
A large amount of food is being heated up.
Start cooking at the highest power level and then
turn down to a lower one manually later on.
The pan is not conducting heat properly.
Use a different pot or pan which conducts heat
properly.
The food in the pan is
barely heating up or is
not heating up at all.
The pan is not conducting heat properly.
Use a different pot or pan which conducts heat
properly.
The pan is too large for the cooking zone.
Use a smaller pan.
The outer ring of a double or extended cooking zone
is not switched on.
Switch the outer ring on.
The heating element for
one of the cooking
zones switches on and
off.
This “timing” of the element is normal. It is caused by
the electronic temperature control (see “How the
cooking zones work”).
If the heating switches on and off at the highest
power level, the overheating protection has been
triggered (see “Overheating protection).
One or more residual
heat indicators are
flashing.
There was an interruption to the power supply during
operation or when residual heat was present.
Summary of Contents for KM 6564 FL
Page 66: ...Electrical connection 66 Wiring diagram ...
Page 69: ......
Page 70: ......
Page 72: ...M Nr 11 240 720 00 en GB KM 6564 FR KM 6564 FL KM 6565 FR ...
