Before using for the first time
22
Con@ctivity via a direct WiFi
connection (Con@ctivity 3.0)
Pre-requisite:
– The WiFi stick supplied with your
appliance must be fitted
– WiFi-enabled Miele cooker hood
If you do not have a home network, you
can establish a direct connection
between the hob and the cooker hood.
Switch the cooker hood off.
Press and hold the
(
B
*) control.
Press the
(
1
*) control at the same
time.
* Cooker hoods with sensor controls.
2
will light up constantly, and
3
will flash
on and off.
The cooker hood will be ready for
connection in the next two minutes.
Switch the hob on.
Touch the 0 sensor control on any of
the numerical keybanks.
Touch and hold the 0 and 7 sensor
controls on the numerical keybank at
the same time for 6 seconds.
The seconds can be seen counting
down in the timer display. After the 6
seconds have elapsed, a progress light
appears during the connection attempt.
If the connection was successful, the
code
:
appears in the timer display.
If the connection could not be
established, the timer display will show
the code
:
. Repeat the steps above.
When successfully connected,
2
and
3
will light up constantly on the cooker
hood.
Quit connection mode on the cooker
hood by pressing the run-on
control
.
Con@ctivity has now been activated.
With a direct WiFi connection, it is not
possible to connect the hob and the
cooker hood to a home network. If this
is desired later, the direct WiFi
connection between the hob and the
cooker hood must first be
disconnected (see “Resetting
settings” and “Disconnecting the
WiFi” in the installation and operating
instructions of the cooker hood).
Summary of Contents for KM 6564 FL
Page 66: ...Electrical connection 66 Wiring diagram ...
Page 69: ......
Page 70: ......
Page 72: ...M Nr 11 240 720 00 en GB KM 6564 FR KM 6564 FL KM 6565 FR ...
