Touchmaster
®
Conversion Kit
Setup - 7
Remove original VGM electronics.
Locate video connector on monitor board. Record
orientation of red wire into this connector (toward
front or toward rear) and detach connector.
Remove existing CPU Board Assembly with
original wiring attached.
Detach all DC wires that lead to CPU Board
Assembly. Verify power supply connections.
Leave AC
and FG
wires
attached.
TYPICAL
POWER
SUPPLY
REAR
OF
UNIT
Open cabinet door. Disconnect touch screen
connector and/or touch screen controller cable
connector, depending on model.
You may have one or
both of these connectors.
COIN
OR
FRONT
OF
UNIT
FAN
SPEAKER
1
2
4
3
5
6
COIN LOCKOUT
POSSIBLE
VIDEO
CONNECTOR
ORIENTATIONS
RED
WIRE
CPU
BOARD
ASSEMBLY
SURGE
PROTECTOR
(not on all
models)
Disconnect: 9- or 15-pin coin mechanism cable,
2-pin DC fan connector (some models do not
have one), 2-pin speaker connector, coin
lockout connector (if applicable).
TOUCHSCREEN
CONNECTOR CABLE
TOUCHSCREEN
CONTROLLER
CABLE
DC Volt.
TOUCHSCREEN
CONTROLLER
Disconnect and remove touchscreen controller.
Remove any key plugs in connector cable
sockets. Leave cable in unit. Retain mounting
hardware (nuts or hook-and-loop fastener).
TOUCHSCREEN
CONNECTOR
CABLE
