Setup - 16
Midway Amusement Games, LLC
VERIFY NEW EQUIPMENT OPERATION
1. START UP Plug in the VGM and turn on power. The CPU Board Assembly LEDs should illuminate.
After the Touchmaster
®
logo and game version appear on screen, close the cabinet door.
2. ADJUST MONITOR Correct size and position of on-screen video if needed.
3. CALIBRATE Perform a touchscreen calibration. This sets the new values into the game memory.
INCORRECT TOUCHSCREEN ORIENTATION
4. In the calibration test, a vertical and horizontal line should cross beneath your finger. If the
touchscreen is inverted (that is, touching the screen in the lower left corner causes a reaction in the
upper right corner) your original equipment was inverted. You can correct this by following the
procedure on the next page. If you do not have an inversion problem, skip to the last page of this
chapter.
CONTROLLER VERSION
RETURN
Your
finger is
here.
The screen
registers it
here.
