Midway Cruis'n Exotica, Operation Manual

Page: 50 / 109

Service - 6
To service the Fluorescent Lamp or Starter…
Refer to Marquee Service illustration.
Ø
Switch off the power to the game machine and unplug the AC line cord.
Ø
Lift open the Marquee Housing. Refer to service instructions for Marquee.
Ø
Reach up inside the opening in the cabinet and remove the fluorescent lamp locks.
Ø
Both the fluorescent tube and the starter require a quarter turn for removal. Grasp the tube or
starter, give it a quarter turn and pull it from its socket.
Ø
Carefully place a new starter or tube into the sockets and rotate it a quarter turn to reinstall.
Ø
Reinstall both fluorescent lamp locks. Clean the tube to remove fingerprints and dust.
WARNING
Fluorescent tubes implode on impact when dropped. Use care in handling.
To service the Cabinet Speakers…
Refer to Marquee Service illustration. Speakers are located on the underside of the marquee
housing.
Ø
Switch off the power to the game machine and unplug the AC line cord.
Ø
Lift open the Marquee Housing. Refer to service instructions for Marquee .
Ø
Reach up inside the opening in the cabinet and disconnect the speaker wires, including the
ground strap.
Ø
Remove the nuts on the mounting screws before removing the speakers from the enclosure.
Ø
Perform the desired repair or equipment replacement.
Ø
Carefully reseat the seals upon completing any task in the speaker enclosure.
Ø
Reconnect the wires, including ground. Refer to the Cabinet Wiring Diagram for correct speaker
polarity.
NOTE: The speakers are magnetically shielded to prevent video monitor color impurity. Be sure
that any replacement speakers are also magnetically shielded.
To service Viewing Glass…
It is recommended that two service personnel be present when servicing the viewing glass. Refer to
Viewing Glass Service illustration.
Ø
Switch off the power to the game machine and unplug the AC line cord.
Ø
Remove the Control Cabinet. Refer to service instructions for Control Cabinet.
Ø
Lift open the Marquee Housing. Refer to service instructions for Marquee.
Ø
Label and disconnect all wiring. Disconnect one end of the tension chain. Close the marquee.
Ø
Remove the tamper resistant screws from the hinge for the marquee located at the top rear of
the cabinet. Both service personnel should grab an edge of the marquee housing and lift it off
of the cabinet. To prevent scratches, the marquee housing should be placed on a cloth
covered work surface.
Ø
Remove the tamper resistant screws and bracket from the bottom edge of the housing.
Remove the screws and bracket from along the top edge of the housing.
Ø
Gently lift the viewing glass up and clear of the housing. Set Viewing Glass aside.
Ø
Perform the desired repair or equipment replacement.
Ø
Clean the glass before reinstallation.