![background image](http://html1.mh-extra.com/html/midea/tje17gs7-s00n0a/tje17gs7-s00n0a_service-manual_1791424022.webp)
4.11 Mains voltage components (casing removed)
Convection fan: motor
The convection fan motor is a 3-phase AC motor having a maximum speed of 5000
rpm controlled by a motor speed controller.
The windings are thermally protected and in the event of a thermal fault a trip
inside the motor will operate and shut down the motor speed controller.
Convection fan: motor speed controller
The convection motor speed controller provides a 3-phase AC switched mode drive
to the convection motor and is controlled by a digit signal from the SRB.
This allows the motor to be adjusted from approximately 1800 rpm to 7000 rpm in
steps of 10%.
Door open, 1800 rpm (7%).
Door closed (not cooking), 2150 rpm (17%).
Door closed (cooking), speed as specified by program or setting up to a maximum
of 5000 rpm (100%).
Convection fan: LED status display
Inverter Off / No supply, LED OFF.
Power On / Ready, LED ON continuously.
Inverter Running, LED ON continuously.
Fault Condition, LED flashes ON/OFF 3-9 times per second.
Fuse
NOTE :
A mircorwave leakege test must always be performed when the unit is serviced
for any reason.
Make sure the wire leads are in the correct position.
When removing the wire leads from the parts, be sure to grasp the connector, not
the wires.
NOTE: If the fuse is blown by improper switch operation
replace the defective switch and thefuse at the same time.
Replace just the fuse if the switches operate normally.
Check for continuity of the
fuse with an multi-meter.
Normal
Abnormal
2
.
3
.
1
.
20