Midea MONB-76C, Technical Manual

Page: 85 / 87

Midea R22 T1 side-discharge duct manual MCAC-RTSM-201301-01
74
10) Query for Initialization Function Parameters
After setting the initialization function, use the following method for query:
※
Long press FAN SPEED for 2 seconds to enter into the query interface.
※
After enter to the interface, the LCD temperature display area, minute display area will
display a series of numbers, which is the current initialization parameter value. If the current
initialization function is cooling and heating (00), no power-off memory (21), the filter screen
cleaning time is 5000 hours (33), centigrade display (60), their combination is 0130, and it
will display 0130.
※
After enter to the interface for 3 seconds, it will automatically exit.
※
Under this interface, it will not respond any key operation.
11) Indoor unit address setting and query
※
Long press the LOCK key for 5 seconds, enter into the indoor unit address setting interface.
※
After enter into the interface, the temperature display area will display 00 , means the address
which is going to be set, then press TEMP
▲
and TEMP
▼
to select the address, and then
press the FAN SPEED key to finish indoor unit address setting.
※
After enter into the interface, press MODE key to query the address.
※
Under the address setting interface, long press LOCK for 5 seconds again, then it will quit the
indoor unit setting interface.
9.5 Wired controller installation

Accessory of wired controller
Accessory name Quantity Remarks
Wired controller 1 With cover.
Wood mounting screw 3 M4×20, for mounting on the wall.
Mounting screw 3 M4×25, for mounting on the electrical switch box.
Installation manual 1 \
Owner’s manual
1 \