Midea MONB-76C, Technical Manual

Page: 86 / 87

MCAC-RTSM-201301-01 Midea R22 T1 side-discharge duct manual
75

Assemblies on the installation site
Name
Quantity
Remarks
Embedded
into wall
Embedded
onto wall
5-core shielded cable 1 1
Take 0.05mm
2
×5 cable below
15m length.
Switch box 1 \ \
Wiring Tube (Insulating
sleeve and tightening screw)
1 \ \

Installation procedure
※
Circuit of wired controller is low voltage circuit. Never connect it with a standard 220V/380V
circuit or put it into a same wiring tube with the circuit.
※
The shield cable must be connected stable to the ground, or transmission may fail.
※
Do not attempt to extend the shield cable by cutting, if it is necessary, use terminal
connection block to connect.
※
Wired controller installation size refers to the following picture (Unit: mm):
※
Turn a screwdriver at the concave on bottom panel of the wired controller to remove the
back cover.