Midea MONB-76C, Technical Manual

Page: 79 / 87

Midea R22 T1 side-discharge duct manual MCAC-RTSM-201301-01
68
9.2 Introduction of function buttons on the wired controller
①
MODE button: It is used to select mode, push the button one time, then the operation modes will
change in turn as follows:
Note: No heating mode if wired controller is set as the cooling only.
②
TIME ON button: Push the button to set timer on, each time push the button, the time moves
forward by 0.5 hours. When the setting time is over 10 hours, each time push the button, the time
moves forward by 1 hour. If want to cancel the timer on, then adjust the time of timer on as 0.0.
③
TIME OFF button: Push the button to set timer off, each time push the button the time moves
forward by 0.5 hours. When the setting time is over 10 hours, each time push the button, the time
moves forward by 1 hour. If want to cancel the timer off, then adjust the time of timer off as 0.0
④
CLOCK button: Normally display the clock set currently (display 12:00 for the first electrifying or
resetting). When push the button for 5 seconds, the hour part on the clock display flashes every 0.5
seconds, then push
▲
or
▼
to adjust hour; Push the button CLOCK again, the minute part flashes
every 0.5 seconds, then push
▲
or
▼
to adjust minute. When set clock or alter clock setting, must
push the OK button to complete the setting.
⑤
OK button: The button is used at the state of clock adjustment. After select the time, push the
button to confirm then exit, the current clock will display.
⑥
RESET button (Hidden): Use a small stick with a diameter of 1mm to push the RESET button,
then the wired controller will get into the condition of resetting.