–
30
–
Washer Components
Slide the top panel rearward 1 inch then lift the
panel.
2.
Service Panel
To remove the service panel:
Knock on the service board door with a flat
head
.
Pull the service
door
down.
1.
2.
Top Panel
WARNING:
Sharp edges may be exposed when
servicing washer. Use caution to avoid injury and
wear Kevlar gloves or equivalent protection.
Note:
Combined Phillips-head/square-drive recess
screws can be utilized throughout this appliance.
Either Phillips or square-drive screwdrivers can be
used to extract or install these screws.
Removal of the top panel provides access to the
control panel, dispenser, water valve, water level
control, and line
fi
lter. The top panel is held in place
by a top cover and 3 screws on the back.
To remove the top panel:
Remove the 3 Phillips-head screws that attach
the top cover, then pull the cover rearward.
Note:
It may be helpful to place a putty knife along
the top seam between the cover and control panel,
then tap lightly rearward.
1.
Rear View
Top Panel Screws
3. Remove the two screws.
4. Remove protect cover with a flate head.