–
33
–
Door Lock
The door lock contains a door switch and solenoid
operated locking and unlocking mechanism. A
release
hook,
located at the middle, allows for
manual unlocking of the door.
The door locks when a cycle is entered (Wake-up
routine) and during every cycle. The door unlocks at
the completion of a cycle.
The door will not open when:
The water level is higher than
main wash level
Water temperature is above
1
60
°F (
71
°C)
Wash basket is rotating
Speci
fi
c failures associated with the door lock
can initiate error codes E
30
thru E
30
. (See
Service
Test Mode
.)
The door lock is held to the front panel with
2
Phillips-head screws. The door lock is accessed from
the front of the washer when the right side of the
gasket is partially pulled back.
To remove the door lock :
Remove the
2
Phillips-head screws that hold the
door lock to the front panel.
•
•
•
1.
(Continued Next Page)
To remove the control board assembly:
Remove the control panel. (See
Control Panel
.)
Pull the cycle knob off.
Remove the Phillips-head screws that hold the
control board assembly to the control panel.
1.
2.
3.
Release the hook and remove the control
board assembly from the control panel
4.