Line Filter
The line
¿
lter helps to smooth out any
À
uctuations in
voltage, protecting the control board and providing
more reliable operation. The line
¿
lter is installed on
the interior side of the rear panel, and is located left
of the water valve.
To check the line
¿
lter, look for the outer surface
to be burnt by heat or a power surge. The
¿
lter
resistance should be approximately 0
:
between
the black (top) wire terminals and 0
:
between the
white (bottom) wire terminals.
To remove the line
¿
lter:
Remove the single black (top) and single white
(bottom) wires.
Disconnect the wire harness by pressing the tab
and pulling outward.
Press the locking tab and remove the ground
wire.
1.
2.
3.
4. Remove the 1 Phillips-head screws that hold
the filter to the frame.
5. Move the filter to the right.
36
