Middleby Marshall X55G Series, Owner'S Operating & Installation Manual

Page: 21 / 46

SECTION 2
INSTALLATION
21
B. Stacking
NOTICE
Middleby Marshall STRONGLY RECOMMENDS that
the X70G/X55G oven cavities be stacked only by
AUTHORIZED PERSONNEL.
NOTICE
DO NOT stack X70G/X55G ovens underneath or
between PS770/PS570 oven units.
Contact your Middleby Marshall Authorized Service
Agent for complete stacking instructions.
1. Stack an oven cavity on top of the lower oven.
Check the following:
− The lower oven and base pad assembly is
level.
−
Insulation is installed on the top of lower
oven.
− The gasket material on the control boxes
is in proper position.
−
All four sides of the lower lip (bottom edge
of the oven cavity) overlap the top of the
lower oven.
−
The oven is firmly seated.
−
The top insulation layer is installed
smoothly and fully covering the metal
panel.
See Figure 18.
2. For triple ovens, repeat Step 1 to install the top
oven cavity. DO NOT stack X70G/X55G ovens
between PS770/PS570 oven units.
3. Install the top panel using the screws included in
the kit, as shown in Figure 17 and Figure 18.
Stacking Order
C. Restraint Cable Installation
Because the oven is equipped with casters, a restraint
cable assembly must be installed to limit the
movement of the appliance without depending upon
the connector and the quick disconnect device or its
associated piping. One end of the cable is anchored to
the snap clip on the underside of the base pad while
the other is anchored to the wall. See Figure 19.
Installing the Restraint Cable
After connecting the restraint cable, move the oven to
its final location. Adjust the bottom (hex) sections of
the adjustable legs so that the casters are off the floor.
For triple ovens, lock the two front casters.
The restraint cable is connected to the spring snap
located at the back-center of the base underside. The
3/4" eyebolt must be anchored to the wall or floor to
attach the other end of the restraint cable.