Middleby Marshall X55G Series, Owner'S Operating & Installation Manual

Page: 20 / 46

SECTION 2
INSTALLATION
20
III. ASSEMBLY
A. Base Pad and Leg Assembly
1. Install the four leg extensions onto the base pad
using the 1/2"-13 x 1-1/4" hex screws, 1/2" flat
washers and 1/2" lock washers supplied in the
base pad kit. See Figure 15. Check that the
orientation of the adjustable 6" leg holes in the leg
bottom is consistent (all to the inside or all to the
outside). The adjustable leg mounting hole is
closer to the edge of the leg than the caster
mounting hole. Install the spring clip for the oven
restraining cable to the hole in the bottom middle
of the base pad. This clip will attach to the restraint
cable that keeps the oven from moving too far
when installed on casters.
Leg Extension and Caster
Installation
2. Install one caster and one adjustable 6" leg onto
each leg extension and tighten securely in place.
3. Orient the base pad assembly such that the
restraining clip is in the rear. Install the lower oven
cavity onto the base pad. See Figure 16.
Base Pad Installation
4. For single ovens ONLY:
Install the top panels using the screws included in
the base pad kit, as shown in Figure 17. Then, skip
ahead to Part C, Restraint Cable Installation.
Top Panel Installation
For double or triple ovens:
The Oven Top Panel Assembly is already installed
on the designated TOP oven. Continue on to Part
B, Stacking.
NOTICE
When adding a third oven cavity, DO NOT install top
panel onto the triple ovens until AFTER re-stacking the
oven cavities. See Part B, Stacking.