Middleby Marshall PS629G Series, Owner'S Operating & Installation Manual

Page: 43 / 52

SECTION 4
MAINTENANCE
43
7. Reconnect the outside master links.
8. Replace all parts removed from the oven.
G. Attaching Drive Chain
1. If drive sprocket assembly was removed,
reassemble it into the conveyor drive shaft. Be
sure the flat on the end of the drive shaft aligns
with the set screw in the conveyor shaft collar.
Once in place tighten the 3/32" set screw.
2. Lift the conveyor and install the drive chain to the
conveyor drive sprocket and motor sprocket.
3. The angle plate located on the underside of the
conveyor must be against the lower end plug. This
is true on both sides of oven.
4. Reattach the conveyor guard to the control panel
and secure two screws.
5. Install the upper end plugs. Be sure to tighten two
wing screws on the end plugs.